History

Circuitboard (Door Control)

## Circuitboard (Door Control)

:::infobox
| Property | Value |
|----------|-------|
| Stacks | ?? |
| Created With | [Electronics Printer](/wiki/electronics-printer), [Fabricator](/wiki/fabricator) |
| Cost | 5g [[Copper Ingot |

![Circuitboard (Door Control)](Circuitboard door control.jpg)
:::

## Description

[Circuitboard (Door Control)](/wiki/circuitboard-door-control) can be placed inside of a [Console](/wiki/console) to form a Door Control Console. It is one of many [Circuitboards](/wiki/circuitboard) that can be fitted to a Console.


## Console (Door Control)

:::infobox
| Property | Value |
|----------|-------|
| Placed With | [Kit (Consoles)](/wiki/kit-consoles) |
| Placed On | Small Grid |

![Console (Door Control)](Console door control.jpg)
:::

## Door Control

The Door Control console allows the remote operation (opening and closing) of [doors](/wiki/door). When connected to one or several [Motion Sensors](/wiki/sensors) the console will open the door when a sensor is activated and close the door when all sensors are clean.


## Console (Door Control) in setup mode

:::infobox
| Property | Value |
|----------|-------|
| Placed With | [Kit (Consoles)](/wiki/kit-consoles) |
| Placed On | Small Grid |

![Console (Door Control) in setup mode](Console door control setup.jpg)
:::

## Setup

Setup mode can be entered by placing a [Data Disk](/wiki/data-disk) into the slot on the [Console](/wiki/console).
When in setup mode, all objects with data access available to the console are listed, however only doors are available to be selected (highlighted green).
When the console leaves setup mode, doors which had been selected are toggled.


## Manual Operation Disabled

:::infobox
| Property | Value |
|----------|-------|
| Placed With | [Kit (Consoles)](/wiki/kit-consoles) |
| Placed On | Small Grid |

![Manual Operation Disabled](Composite door disabled.jpg)
:::

## Manual Operation

The setup mode also allows for enabling/disabling manual operation of the doors. If this is chosen, then the configured doors which normally have their own toggle available become visibly disabled.

## Mode

The setup mode also allows for choosing between Link mode and Toggle Mode. IN Link mode, all selected devices will be turned either on or off depending on the current setting.
In Toggle mode, selected devices will be toggled from their current state to the alternate state, allowing for different devices to be in different states at the same time.