Circuitboard (Power Control)

Circuitboard (Power Control)

Setup

Setup mode can be entered by placing a Data Disk into the slot on the Console. When in setup mode, all objects with data access available to the console are listed. When the console leaves setup mode, devices which had been selected are toggled.

Console (Power Control) in setup mode

Manual Operation

The setup mode also allows for enabling/disabling manual operation of the selected devices. If this is chosen, then the configured devices which normally have their own toggle available become visibly disabled.

Manual Operation Disabled

Mode

The setup mode also allows for choosing between Link mode and Toggle mode. In Link mode, all selected devices will be turned either on or off depending on the current setting. In Toggle mode, selected devices will be toggled from their current state to the alternate state, allowing for different devices to be in different states at the same time.